Raven Cruizer II Návod k obsluze stáhnout pdf (Strana 16)

Chapter 4

10 SmartBoom and SmartRow Installation and Operation Manual

7. Configure the Implement Locations - If this is a standard boom configuration, use the SmartBoom

Autoloaded feature to configure the location of each boom section with respect to the GPS

antenna. If a custom boom configuration is used, use the optional boom configuration screens to

set the location of each boom section with respect to the GPS Antenna.

FIGURE 1. Boom Location Example

8. Set the Look Ahead Times - Use the SmartBoom Configuration menus to set the Turn On and Turn

Off Look Ahead Times. The default setting is 0.1 seconds.

9. Set the Override Time - Use the SmartBoom Configuration menus to set the Override Time. The

default setting is 5 seconds.

10. Set the Percent Coverage - Use the SmartBoom Configuration menus to set the Percentage

Coverage. The default setting is 100 percent.

11. Select The Booms To Be Controlled - Use the SmartBoom Configuration menus to select which

booms will be controlled by SmartBoom. The default setting allows SmartBoom to control all boom

sections.

About SmartBoom Jobs

SmartBoom provides several methods of operation. These include:

• Standard Job

• Job with field boundary

• Job with no spray zones

• Job with field boundary and no spray zones

Boom 2 Boom 3

Boom 1

GPS Antenna

Fore/Aft

Left/Right

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 97 98

Žádné komentáře

Raven Cruizer II Návod k obsluze Strana 16