Raven Cruizer II Návod k obsluze stáhnout pdf (Strana 12)

Chapter 3

6 SmartBoom and SmartRow Installation and Operation Manual

GPS Receiver

SmartBoom/SmartRow must receive a GPS signal from a GPS receiver in order to know where the

sections are located. Any GPS receiver that supplies the standard NMEA GPS strings at a minimum of

4 Hz can be used.

Connect the supplied GPS Interface Cable (P/N 115-0171-460) to the round connector labeled DGPS

on the back of SmartBoom/SmartRow. Connect the 9-pin connector on the other end of the GPS

Interface Cable (P/N 115-0171-460) to the mating connector on the GPS receiver.

Cruizer Connection

Connect the supplied optional Cruizer Interface Cable (P/N 115-0171-835) to the round connector

labeled DGPS on the back of SmartBoom/SmartRow. Connect the 9-pin connector on the other end of

the GPS Interface Cable (P/N 115-0171-835) to Port A.

Console Connection (SmartBoom Only)

SmartBoom receives information on boom status from the Raven control console. In order for

SmartBoom to receive section information, a serial interface cable must be connected between the

Raven control console and SmartBoom.

Connect the supplied serial console communications cable (P/N 115-0171-119) to the circular

connector labeled “Console” on the back of SmartBoom. Connect the 9-pin connector on the other end

of the cable to the corresponding 9-pin jack on the back of the Raven control console or on the console

harness.

Note: For 4400/4600 consoles, make sure you set the Data Direct menu to “Pass through

communications port” and the stop bits to “2 stop bits.” Also, ensure the baud rate for port

C on the SmartBoom/SmartRow controller matches the baud rate for the serial port of

your SCS console.

If you are installing SmartBoom on a machine without a Raven console, you do not need to connect a

console with the serial connection. Make sure SmartBoom Console Port option is set to “None.” See

the Sections Configuration Menu section in Chapter 8 for more information on using the Console Port

Screen.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 97 98

Žádné komentáře

Raven Cruizer II Návod k obsluze Strana 12